Strong and Fast
The CLM-3 motor is a very strong and fast than motor. It drives even heavy, difficult-to-operate lenses under extreme, cold temperature conditions.
Modular System
The CLM-3's modular concept separates motor unit, gear, cable and bracket to make handling and maintenance much easier.
Flexible Setup
To provide more flexibility and various mounting options, the gear attaches on either side and the extension bracket can be mounted horizontally or vertically over a quick clamp shoe. Due to the different types of available teething gears, the CLM-3 is fully compatible to all existing lens gear systems on the market. Additional inserts make mounting to 19 mm, 15 mm or 5/8” support systems possible.
ARRI CLM-3 Compatibility July 1st, 2013
|
Unit |
noticeable more Torque than CLM-2 |
maximum Torque supported |
Software Packet |
|
ALEXA PLUS ALEXA XT PLUS ALEXA XT STUDIO |
x x x |
SUP 7.0 or later |
|
|
UMC-3A |
x |
Packet 03A or later |
|
|
UMC-3 |
x |
||
|
416 PLUS / HS |
x |
Packet 04A or later |
|
|
435 Xtreme |
x |
Packet 04A or later |
|
|
435 Advanced + FEM-2 |
x |
||
|
D21+ FEM-2 |
x |
Packet 1.17 or later |
|
|
ZMU-3 |
x |
Packet 02A or later |
|
|
ARRICAM ST/LT + LDB |
no CLM-3 support |
||
|
UMC-1 |
no CLM-3 support |
Information to the user:
Class A Statement:
Note: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the interference at his own expense.
